Magnum Baby Countryside Corn/ Biomass / Wood Pellet Stove Owner’s Manual

May 8, Leave a Comment Yurts are a reflection of the beauty and simplicity of nature. Their rounded structure, illuminant lighting from the skylight, and open feeling can all put us more in touch with our natural surroundings. Fortunately, with good yurt heating, these beautiful structures can be wonderfully cozy as well. There are a number of ways to install yurt heating; almost any conventional method can be used. Many of our customers prefer wood stoves, others choose pellet or propane stoves, some use central heating or electric heaters, and some even put in radiant floor heating. If ductwork is required for any heating solution, it can be installed below the yurt floor.

Passion. Pride. Craftsmanship.

If you would like to heat your home the traditional way, check out antique wood stoves. When you choose one that connects to a chimney, it draws in fresh air from the outside world and generates comforting warmth in which you can bask. If you enjoy taking care of the environment, using a wood-burning stove can work to your advantage. By using wood pellets, you opt for a biomass fuel that is less harmful to the environment than alternatives like gas.

When you choose an antique wood-burning stove in cast iron, you are opting for a material that withstands the pressure of heat and does not deform, allowing you to enjoy it for years to come.

Adding a blower to a wood stove is a great way to spread the heat generated from the stove to the surrounding room. A blower will greatly increase the efficiency of the wood stove because it distributes the heat to the entire room rather than just the immediate area in front of the stove.

Burning Solid Fuels Proper draft setting will be discussed later in this manual. The point we wish to make here is that your Magnum stove, due to the nature of solid fuels, will require brief periodic attention. Please do not expect to light your stove and walk away from it until you want to shut it off in the spring. If there was shipping damage, be sure to report it to your Magnum reseller, or the shipping company that delivered your unit.

The following installation guidelines must be followed to ensure conformity with both the safety listing of this stove and to local building codes. Installation Precautions If the home was not designed with proper heat circulation, the stove will not perform properly. Make sure that the installer looks at the entire home as a unit when installing your Magnum appliance.

Mazona Small Orlando 5.6 kW Multi Fuel Wood Burning Stove

We at the Antique Stove Hospital have noticed a troubling trend in the past months. There have been several businesses around the country that have opened up with very similar names to ours. If you are questioning the authenticity of your potential purchase, it is important to make sure that you are buying from either Emery Pineo or Brandon Pineo at the Antique Stove Hospital in Little Compton, Rhode Island. If you have been solicited by ANY other individual who represents themselves as being part of the Antique Stove Hospital, please let us know so we may take appropriate legal action.

Here at the Antique Stove Hospital we specialize in returning wood and coal stoves to day one condition.

This type of stove has a round, steel flange emerging from the top that allow for easy hook-up. Its only a matter of matching the pipe to the flange. Special tools or training are not necessary.

And they are manufactured by approved sources located in Shipshewana, Indiana. We design and build our outdoor wood and coal burners with a cost effective heating system which can be used in conjunction with almost any interior heating systems that are being currently used in homes today. Thousands of dollars can be saved using wood or coal rather than most other fossil fuel alternatives. You may also check the above pages or the video below for more information about our products.

Many people ask us how our outdoor wood and coal boilers work to provide heat in a home. Most all outdoor furnaces burn wood or coal to the heat water which is transported to your furnace which provides heat to your house or to any building it heats.

Using Your Fireplace or Stove During a Power Outage

The pot belly stove has been a traditional cooker throughout American history. Many people like to have the look in their home to remind them of the one room schoolhouses and general stores of yesteryear. To install your pot bell stove, follow these five steps.

A decade earlier a wood-burning stove had been installed in the house. It was a well-made stove, set on a masonry base, and was vented into a structurally sound chimney.

I’d like to add a second thermostat near the one for my gas furnace. I’d like to wire it in such a way that it turns on the blower motor in the main furnace when the house gets cool, but I want to set the main thermostat lower than the wood burner thermostat in case the wood fire gets low and the gas burner will kick in. I just don’t know how thermostats are wired. EPMiller Nov 24, , If I understand your post correctly you are asking for something that is a bit beyond simple thermostat wiring.

If you don’t know how to wire a basic thermostat to your wood stove, I think it may be a bit beyond you to do a thermostat, relay and probably transformer just with help from here. A decent HVAC tech won’t have any trouble, but I’ve even seen them do some convoluted solutions to non-standard setups like this.

Gas Stoves

Myth – I can retro fit this to my existing wood heater Fact – Only if the wood heater is tested and approved to have a hot water jacket fitted. Myth — The hot water systems give you bad hot water pressure Fact — Actually this is wrong: Myth — You can’t use solar with a wood stove Fact — Again, this is incorrect, you can:

When it came time to hook up the stove, however, we learned that experts have mixed thoughts on ducted outdoor air for wood stoves. We decided to hook up the stove without the ducted outdoor air supply and see what happened.

Corn burning stove Keep in mind when you read these comments or ask questions from someone who has one of these products, some people realize they have not made the right buying decision and are embarrassed to admit it. You have to ask a lot of questions and check with folks who have at least a few years experience with the product they bought. We refer to the term BTU in some of these comparisons. BTU means British thermal units, which is a common measurement of heat used for any kind of heating device.

It is necessary for a gas or oil furnace to produce this amount of heat to take the bi-products of combustion out of the home. Most solid fuel furnaces and stoves are grossly inefficient compared to oil or gas appliances. There are several reasons for this. Wood with different amounts of water in it because of drying time burns at different temperatures. Wet wood burns at a lower temperature and is therefore less efficient because of incomplete combustion.

Forty per cent of the energy in wood is in the form of an unburned gas as it leaves the flame because it starves for oxygen as it leaves the flame.

Hook up thermostat for Outdoor Wood Boiler

We at the Antique Stove Hospital have noticed a troubling trend in the past months. There have been several businesses around the country that have opened up with very similar names to ours. If you are questioning the authenticity of your potential purchase, it is important to make sure that you are buying from either Emery Pineo or Brandon Pineo at the Antique Stove Hospital in Little Compton, Rhode Island. If you have been solicited by ANY other individual who represents themselves as being part of the Antique Stove Hospital, please let us know so we may take appropriate legal action.

A wood burning fireplace can bring warmth and comfort into your home. Proper installation is very important when installing a wood burning fireplace. With hard work and preparation, you can have a safe place to enjoy the benefits of a fireplace.

Click on picture to enlarge The Kitchen Queen wood cook stove Big Difference The big difference between the Kitchen Queen wood cook stove and all other cookstoves that we know of is the route the heat and flue gases take around the oven. All other stoves run the heat over the top of the oven and down the far side, often past a cooling surface such as a reservoir.

Then it goes under the oven, where most of the time the flue gases have dropped below degrees. Then these gases will condense or liquefy into liquid creosote leaving a sticky mess, not to say anything of rotting out the stove. In this method all your heat must be radiated down into the oven. And heat does not readily travel down, therefore most of your heat will be in the top of the oven, resulting in bread being burned on top and under baked on the bottom.

The heat and flue gases on the Kitchen Queen are directed under the oven first. It will actually flow up through the oven resulting in an evenly heated oven. N ext, the heat travels up the far side, with never a cooling surface to cool down the gases. Then over the top where there is still plenty of heat left to radiate down into the oven to nicely brown your bread or whatever. Your bread will never come out under baked on the bottom and over baked on the top.

Another big Kitchen Queen difference is the reservoir. It is located on the back behind the top shelf where it will not take up any extra floor space. The water is not just heated by heat radiating from the stove.

what is the longest burning wood stove out there ???

This is the Easiest System for Self Installers! We help you every step of the way! You will NOT void the warranty by installing the furnace yourself! Every furnace comes with a complete detailed manual with lots of pictures and diagrams! If you have any technical questions or need any help whatsoever, please call Installing an outdoor wood furnace can be broken down simply.

With the environment in mind, wood-burning cookstoves can serve not only as a heating source, but as a cooking source, a recreational fire-viewing stove and a source of hot water. Don’t forget the added perk of a lower gas bill!

Power is another aspect, which distinguishes pellet stoves and wood stoves. These wood stoves work as fireplaces — all you need to do is to add some wood, then light it and stoke as needed. They can completely operate without requiring any power like electricity. Because of this reason, they are always usable so long as the timber is available.

No matter what, pellet stove always needs the power to operate. And electricity is the keystone in its operation. Therefore, if its power goes out, you have to say goodbye to your fire. Electricity gives power to a motorized hopper, which feeds pellets into your stove. Rating of Eco-friendly Pellet stove: When coming to eco-friendly, pellet stoves will be the winners. They are so friendly to the environment that the EPA does not even monitor their usage. The greatest feature of a pellet stove is that the material of pellets comes from wood waste.

Therefore, when using the pellet stove, you can recycle and help to keep your food waste out of the landfills. About carbon emissions, when being burned, pellets stoves can emit 0.

The BEST Wood and Coal Burning Heating and Cooling Boiler!

Someone with more control knowledge might help you if you want it all on one thermostat and it will have to be the correct model for doing that. The boiler is set at 74 and the gas is set at 70 or something. If the wiring and control is totaly escaping you you might want to invest in a furnace man for a few hours but you need to be able to tell him exactly what you want done which is simply switch the fan on high speed and off with a thermostat for the boiler heat and the gas furance and control gets left alone.

Now I dont want to add to your confusion at this point but the one and only potential problem with this type of control is that if you let the fire go out on the boiler the fan is going to run continuously as the thermostat is going to be calling for heat that cant be delivered, Got it?

BRUTE FORCE , BTU RATING The smallest Brute Force outdoor wood furnace is capable of heating up to 5, square feet. This stove is a good option for a small or medium size home.

With the severe winter weather expected to hit much of the East coast this week, losing power — and subsequently, heat — may be a very real concern. Pellet stoves and inserts require electricity to light the flame. The exception to this is the Mt. This stove and insert can be outfitted with an optional 12 volt power cord that will hook up to a deep cycle marine battery to operate you stove.

Also, keep in mind that power outages can cause power surges that can damage circuit boards and motors. Another option for lighting your stove is to plug it into a steady-state generator, if one is available. Vernon AE Pellet Stove Batteries should be used as a power source only in the event of a power outage, as battery longevity can be affected by the temperatures of the appliance.

So, when your power is restored, remove the batteries and keep them handy for the next time you may need them. Remember that fireplaces and stoves make fire heat, so be sure no flammable objects are near them, and please keep children a safe distance away. If your hearth appliance has been exposed to water in any level, please contact your local dealer. Exposure to water can result in irreversible damage to many heating appliances.

Click here for warranty information.

Can You Install a Wood Burning Stove If You Don’t Have a Chimney?

Outdoor Wood Boilers Where does a wood stove go? These devices are notoriously polluting and inefficient. They require lots of electricity to run and they waste much of the energy value of the firewood they burn.

Apr 06,  · okay i will be using a wood burning stove/ to heat home and for hot watter so is it possible to hook up to ductwork and is it safe, has it been Status: Resolved.

Combustible surfaces include floors, furniture, and walls of plaster, drywall or paneling. The proper distance from these combustible surfaces is determined by consulting three sources. If the stove is “listed,” which means it was safety tested by an independent testing lab, there will be manufacturer’s recommendations for clearance from combustibles.

If a stove is not listed, follow the National Fire Protection Association recommendations see Table 1 for clearance from combustibles. However, either of these recommendations are superseded by local building codes. Check with the local building inspector to find out what clearance standards are enforced in your area. From Table 1, the distance to unprotected surfaces, especially for radiant stoves, is quite large inches. Thus, most stove installations have some type of non-combustible wall protection behind the stove to allow for installation closer to the wall without presenting a safety hazard see Figure 1.

Asbestos millboard, while it is an acceptable type of protection, is not recommended because of the health hazard from asbestos fibers. If asbestos is used, paint with a high temperature enamel o lock in the fibers.

Wood Stove Installation Video